Friday, 26 April 2019

Shrinking Arduino with Attiny 13a #2 : Burning Bootloader with Uno



If you follow my previous tutorial, now you know how to shrink Arduino circuits using ATTINY 13a. However, as usually you have to burn the Bootloader before start programming. The interesting part is, wiring for burning bootloader and wiring for uploading codes are same. I have already done a tutorial about burning bootoader to arduino Chips. This process is also similar to that process, but you have to do the following settings to do so.


If you have already read the burning bootloader tutorial for ATMEGA328, you may have an adea about burning bootloader. The process of burning Bootloader is as same as the ATMEGA 328P.

Make a shield



Step 01.
Go to File > Preference


STEP 02 : Enter the following url in the box "Additional Boards manager URLs

https://raw.githubusercontent.com/sleemanj/optiboot/master/dists/package_gogo_diy_attiny_index.json



STEP 03: Tools > Boards > Boards Manager


STEP 04 : Search ATtiny



STEP 05 : Click Install button and wait......



STEP 06 : Tools > Boards > Attiny13 or your board as per the chip number


Since I am using Attiny13a,



Now the setting part is completed. You can follow the steps as my previous tutorial for burning the chip.

http://www.SetNfix.com/2019/03/arduino-bootloader-burning.html


If you have ant doubt, please put it in the comments below.

STAY WITH SetNfix

Previous Post
Next Post

post written by:

0 comments: